Is Fl Studio the best voice mixer

How to Mix Music

The basic mixing workflow

What exactly are the basics of mixing? As is so often the case, opinions differ widely - especially when it comes to mixing. Who knows what's right or wrong? Probably nobody. When it comes to mixing, however, there are a few essential basics that everyone should adhere to.

A mix that you can work with

That may sound strange, but the mixing starts before the mix.

What do i mean by that? Very simple: Define the central structures of your mix. Which space do you want to create? Direct and bright? Or distant and reverberant? Work out the special features of your sound while you are recording. Think of the big picture right from the start when choosing your sounds.

Get the most out of your original recordings without over-editing them. You should be clear about what the final mixdown will sound like early on. If the sound sounds good when you record it, you won't have to do a lot of editing later while mixing.

Just take the bus

Imagine a yellow school bus. Now imagine that the passengers are sounds.

This is exactly how a bus works in a mix. By running multiple sounds on one track, you can edit all of them at once. Pretty practical the whole thing. Try a drum bus, for example. This way you can edit all drum sounds as one unit. Edit them all with the same reverb effect so that it feels like they're all in the same room. Or send a delay or compression bus on the way.

Experiment with different sounds on different buses. You'll make some very interesting discoveries, guaranteed!

HOT TIP: If the sound sounds good when you record it, you don't have to change a lot later when you mix it.

Adjust the levels

It's time to give your mix a haircut. Here and there it can certainly be trimmed a little. Pay attention to the level conditions and do not shy away from major interventions. Leave the drums off for a bar, turn up the vocals to full speed for a verse. Let yourself go!

Before you start working on the effects, you should bring the levels to a good starting position. Trim them to avoid clipping and think about headroom early on.

When balancing your tracks, always keep the end result in mind that you are striving for. This will give you a rough idea of ​​how all of the tracks will eventually fit together. You then use the edits you make later to refine your rough ideas.

Panning

What is panning anyway?

Panning helps you control the breadth of your mix. The width is the circumference of your stereo field, measured from left to right. Panning allows you to place your sounds appropriately in your mix, either to the left or right of the center. Place the deeper and heavier sounds like bass and kick drum closer to the center and use them as a central force around which you can build your mix. With everything in the center, your mix will sound flat or crowded.